Urządzenia do kucia [1 - 2 of 2]

Młot pneumatyczny

Reiter Industriewerke Rheinböllen LH 100

Niemcy

1951

używany

na żądanie

INNO32521

Ram weight: 100kg. Including anvil block, anvil, standard dies and motor. Total weight: approx. 3400kg including anvil block. The machine was purchased in working condition in 2019 and has not been operated since. The hammer has very good compression and is in good condition. Low operating hours, no continuous operation. The sliding surfaces of the ram are greased. Documentation available. An on-site inspection is possible.

więcej

Młotek z matrycą o krótkim skoku

Bêché KGH 1,6

Niemcy

1991

używany

na żądanie

INNO32100

A BÊCHÉ hydraulic short-stroke die forging hammer is offered for hot forming and die forging of workpieces. Working capacity: 16kJ, continuous blow frequency at full load: approx. 32/min-38/min, max. blow frequency: 122/min, final ram velocity: 5.1m/s, main drive pump flow rate: 187.5l/min, circulation pump flow rate: 120l/min, oil capacity in the drive head: 550l, clear width between the guides: 520mm, working height to upper edge of insert: 750mm, ram depth: 470mm, insertion depth: 550mm, die height min./max.: 120mm/320mm. Total weight: approx. 23.2t, anvil bed, overall dimensions X/Y/Z: approx. 1485mm/825mm/4552mm, max. space requirement/foundation dimensions X/Y: approx. 3350mm/3300mm. An on-site inspection is possible.

więcej

Wszystkie oferty / Obróbka metali i obrabiarki / Urządzenia do kucia