Screw Compressor

Comair MSK G15/10 AF1N2

Germany

1997

used

on request

INNO30497

A screw compressor is offered. Maximum pressure 10bar, volume flow approx. 2020l/min (2.02m3/min) with separate compressed air tank, galvanized. Viewing possible by appointment.

more

Screw Compressor

Bauer Wolfratshausen C20 Super Silent (C20-10-SS)

Germany

1989

used

on request

INNO30487

Offered are 2 screw compressors with the following features per unit: Power: 15kW, pressure: 10bar, volume flow: 1950l/min (1.95m3/min), speed: 2930rpm, including sound enclosure, 1) year of construction 1989, operating hours: approx. 38100h, 2) year of construction 1986, operating hours: approx. 10600h. Inspection possible by appointment.

more

Refrigerating Machine

Wöhr D20V / D30V

Germany

1998

used

on request

INNO30466

2 oil coolers - through-flow oil coolers: year of construction 1998. Refrigerant: R404A, circulation pump, LAE controller MTR11, suitable for clean oil. Documentation available. 1) Type D 20 V, cooling capacity: 2kW, Walter Procon connector plug, total power consumption 1.7kW. 2) Type D 30 V, cooling capacity: 3.3kW, CEE connector plug, total power consumption 2kW. Dimensions X/Y/Z: approx. 800mm/750mm/1100mm. Inspection possible by appointment.

more

Transformer

Peters & Thieding ZK8 System Calor Emag

Germany

1994

used

on request

INNO30367

Offered is a high-voltage switchgear device ZK8 System Calor Emag from Peters & Thieding. Year of construction 1994, standard series VDE 0670 (IEC 62271), rated voltage 24.2kV, insulation level 50/125kV, rated frequency 50Hz, operating current 630A, short-time withstand current 20kA, short-circuit duration 1s. Viewing is possible by arrangement.

more

Motor

Siemens/vem

Germany

2017

used

on request

INNO30325

One Siemens flange gear motor and two identical VEM three-phase motors are available. 1) Siemens flange gear motor, year of manufacture: 2014, shaft diameter: 80mm, power: 160kW, speed: 1485rpm, gear ratio: 33. 2) 2x VEM three-phase motors, year of manufacture: 2017, power: 200kW, speed: 1490rpm, operating mode: continuous operation, power factor: 0.87, weight: approx. 250kg. An on-site inspection is possible. Individual sale possible.

more

Asynchronous Three-Phase Induction Motor

Vem DSRAN 7132-8WF

Germany

2010

used

on request

INNO30324

Ein unbenutzter VEM 6300V Schleifringläufermotor (Asynchronmotor) steht zur Verfügung. Bauform: IM1001, Schutzart: IP55, Isolationsklasse: F, Nennleistung: 2580kW (2,58MW), Nennspannung: 6300V, Nennstrom: 276A, Leistungsfaktor: 0,89, Rotorspannung: 2370V, Rotorstrom: 680A, Nenndrehzahl: 993U/min, Gesamtgewicht: ca. 14300kg. Maschinendimensionen X/Y/Z: ca. 3600mm/2300mm/2320mm. Die Maschine ist unbenutzt und somit neuwertig. Eine Besichtigung nach Absprache vor Ort ist möglich.

more

Electric Motor

Vem DSRAN 8033-6WF

Germany

2014

used

on request

INNO30302

An unused three-phase electric motor VEM is available. Design: IM1001, protection class: IP55, rotation direction: CCW, insulation class: F, lubrication system: Shell Alvania RL3, rated power: 4600kW (approx. 4.6MW), rated voltage: 6300V, rated current: 460A, power factor: 0.88, rotor voltage: 2000V, rated speed: 994rpm, moment of inertia: 690km/m². Machine dimensions X/Y/Z: approx. 4150mm/2300mm/1900mm, weight: approx. 20000kg. The machine is unused and therefore as new. Documentation vorhanden. An on-site inspection is possible.

more

Boiler Plant

Polytechnik LS 2000 DG

Germany

1997

used

on request

INNO30279

A boiler system with underfeed firing is available. Heating capacity: approx. 2300kW. An on-site inspection is possible.

more

Boiler Plant

Polytechnik PR 2000

Germany

2000

used

on request

INNO30278

A boiler plant is available. Thermal output: 2000kW, water content: 5820l, heating surface: 250m², max. operating overpressure: 4bar, water quality: TRD 612, max. permissible flow temperature: 110°C. An on-site inspection is possible.

more

Chiller

Kratschmayer CW-C11R0411CP

Germany

2023

used

on request

INNO30267

A complete Kretschmeyer chilled water system is available. Cooling capacity: 40.7kW, medium temperature inlet/outlet: 12°C/6°C, max. operating pressure low pressure/high pressure: 18bar/28bar, test pressure low pressure/high pressure: 26bar/40bar, refrigerant: R290, refrigerant charge: 4300g. Machine dimensions X/Y/Z: approx. 2800mm/1350mm/2350mm, weight: approx. 1050kg. Including hydraulic module, cooling water circulation pump, buffer tank, and remote maintenance module (monitoring package). Documentation available. An on-site inspection is possible.

more

Fan

Siemens V-RU-35-250-30H2

Germany

unknown

used

on request

INNO30233

A radial fan with a Siemens three-phase asynchronous motor is available. Air volume flow: 120m³/min, max. temperature: 15°C, max. density: 1.2kg/m³, max. differential pressure: 108mbar, speed: 2950rpm, power: 25kW. Machine dimensions X/Y/Z: approx. 1100mm/1150mm/1350mm. An on-site inspection is possible.

more

Steam Boiler

Weishaupt WM-G30/1-A

Germany

2017

used

on request

INNO30211

Two Weishaupt gas burners including two WMG boilers are available. Output: 2x3.3MW. Documentation available. An on-site inspection is possible.

more

Chiller

Daikin EWQ009ACW1P

Germany

2010

used

on request

INNO30186

A small Daikin chiller with inverter is available. Refrigerant: R410A, refrigerant charge: 2.95kg, max. operating pressure high/low side: 4MPa/3MPa, max. water pressure: 3bar, weight: approx. 180kg. Documentation available. An on-site inspection is possible.

more

Refrigerating plant

Hyfra Alpha 34-2-W-S

Germany

2021

used

on request

INNO30185

Two identical Hyfra refrigeration units are available. Cooling capacity: 25kW, refrigerant: R410A, refrigerant charge: 4kg, max. operating pressure: 42bar, medium: water, pumps process/standard: 2/2, pump type: CM3-4/CM5-5. Machine dimensions X/Y/Z: approx. 1650mm/750mm/1600mm, weight: approx. 500kg. Documentation available. An on-site inspection is possible.

more

Chiller

Ers SC 22.0 VS

Germany

2014

used

on request

INNO30184

A refrigeration unit ERS is available. Refrigerant: R407C, refrigerant quantity: 13kg, heat inlet/outlet temperature: 15°C/20°C, cooling capacity: 25580W, tank volume: 360l, pump capacity at 390kPa: 4.4m³/h, max. operating pressure low/high: 22bar/29bar. Machine dimensions: approx. 1650mm/900mm/2000mm, weight: approx. 930kg. Documentation available. An on-site inspection is possible.

more

Steam Boiler

Jumag DG260

Germany

2017

used

on request

INNO30179

A Jumag steam generator including burner is available. Volume: 45l, max. operating pressure: 13bar, max. test pressure: 23bar, max. temperature: 220°C, heating capacity: 175kW. Weight: approx. 810kg, boiler hours: 3013h, burner hours: 2652h. Documentation available. On-site inspection is possible.

more

Burner

Weishaupt WM-G10/3-A monarch

Germany

2017

used

on request

INNO30128

Fuel: Natural gas, power range: 100kW-1000kW, connection pressure range: 15mbar-500mbar, NOx class: 2. An on-site inspection is possible.

more

Low-Voltage System

Siemens 4GD6164-3ZY

Germany

2013

used

on request

INNO30109

Two low-voltage systems consisting of two Siemens transformers and reactive power control units are available. 1) 3-phase dry-type transformer Siemens 4GD6164-3ZY, year of manufacture: 2013, power: 1250kVA, transformer dimensions X/Y/Z: approx. 3500mm/2400mm/3000mm, weight: approx. 3000kg, reactive power control unit dimensions X/Y/Z: approx. 1000mm/1000mm/3000mm, main low-voltage distribution dimensions X/Y/Z: approx. 3600mm/1000mm/3000mm, doors: 4. 2) 3-phase dry-type transformer Siemens 4GD6164-3ZY, year of manufacture: 2015, power: 1000kVA, transformer dimensions X/Y/Z: approx. 3500mm/2400mm/3000mm, weight: approx. 3000kg, reactive power control unit dimensions X/Y/Z: approx. 1000mm/1000mm/3000mm, main low-voltage distribution dimensions X/Y/Z: approx. 2400mm/1000mm/3000mm, doors: 3. Documentation available. An on-site inspection is possible. Individual sale possible.

more

Compact Gear Motor

Lenze g500-B600

Germany

unknown

used

on request

INNO30095

Six geared motors Lenze in mint condition are available. Gear ratio: 7.617, motor type: G50BB160MVBR3C00, oil type: CLP 460, oil quantity: 1.4l, degree of protection: IP55, insulation class: F, efficiency class: IE3, operating mode: S1, max. power: 7.35kW, max. speed: 2580rpm, weight: approx. 70kg. An on-site inspection is possible.

more

Heat Exchanger

K. Ley/weisstaler/vehterus/gea

Germany

2012

used

on request

INNO30091

Four heat exchangers from various manufacturers are available. 1) Shell and tube heat exchanger K. Ley Maschinen- und Apparatebau, year of manufacture: 1999, material: stainless steel/cast iron, heat transfer surface: 30m²-40m², operating pressure inside/outside: 25bar/45bar, max. operating temperature: 250°C, internal/external volume: 290l/200l, machine dimensions X/Y: approx. 6400mm/400mm, weight: approx. 1800kg. 2) Shell and tube heat exchanger Wisstaler Hüttental, year of manufacture: 1979, heat transfer surface: 80m²-120m², max. operating temperature: 150°C, internal/external volume: 579l/1387l, machine dimensions X/Y: 2500mm/800mm, weight: approx. 2800kg. 3) Shell and tube heat exchanger Vehterus PSHE 3LL-270/5/5, year of manufacture: 2012, heat transfer surface: 19.9m², capacity: 245kW, operating pressure: 16bar, test pressure: 33bar, max. operating temperature: 110°C, internal/external volume: 21.4l/33.2l, machine dimensions X/Y: approx. 850mm/400mm, weight: approx. 300kg. 4) Plate heat exchanger GEA BT30-5C-10V-80, year of manufacture: 2010, heat transfer surface: 5m²-10m², max. operating temperature: 200°C, machine dimensions X/Y/Z: approx. 500mm/350mm/750mm, weight: approx. 520kg. Documentation available. An on-site inspection is possible. A package sale is preferred.

more

All Offers / Energy management